- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,how can I activate MCS8. When trying the command: 5g_rate -h 8 ,I am getting this error: remote cdc header return error code (-29).
if I set the similar command for VHT : 5g_rate -v 0 -s 2
Device used: CYW954907AEVAL1F
Thanks,
Ana
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CYW54907 supports single spatial stream; i.e NSS = 1 as mentioned by the datasheet. That's why when you try to use NSS=2, it throws up an error.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Which version of WICED Studio are you using?
- Are you using test.console example or are you using the test.mfgtest example?
- What is the sequence of wl commands that you have followed?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- I used this version of WICED - WICED-Studio 6.4.0 Installer (Windows)
- I have the CYW54907 Evaluation Kit CYW954907AEVAL1F. I build this ( test.mfg_test-CYW954907AEVAL1F download run) target.
- The sequence of wl commands I attach as a picture.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The version from the device:
..\wl43909B0 --serial 7 ver
7.16 RC99.19
wl0: May 2 2019 02:35:08 version 7.15.168.130 (r714231 WLTEST) FWID 01-a65d4de7
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can use
wl 5g_rate -v 8
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
But I need High throughput from MCS8 till MCS15. And wl 5g_rate -v 8 is smth different .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wl 5g_rate -v 8 is running fine (NSS=1), which was not an issue for me.
As soon I trigger wl 5g_rate -v 8 -s 2 (NSS=2) I get an error.
My aim is to transmit with 2 spatial streams either in HT or VHT (either MCS8 for HT or MCS1-7 with NSS=2).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CYW54907 supports single spatial stream; i.e NSS = 1 as mentioned by the datasheet. That's why when you try to use NSS=2, it throws up an error.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.