USB superspeed peripherals

cancel
Showing results for 
Search instead for 
Did you mean: 
Ask a question

Recent discussions

Sort by:
AKS
USB superspeed peripherals
Hi, I have interfaced the camera sensor to FX3 board. The output data is in the YUV2 format (as default in AN75779). I want to display the data in RAW... Show More
Michael
USB superspeed peripherals
Hi, I am wondering if you have any devices that can convert USB1.0/USB2.0/SPI/I2C/UART to USB 3.0? What I am after is something that can take USB1.0/U... Show More
Ankitvats
USB superspeed peripherals
New at this platform : Using Control Center : Able to flashing in RAM and I2CEEPROM     (no error )                                               but ... Show More
Ankitvats
USB superspeed peripherals
Hi, I just import the project in "EZ USB Suite" tool and try to build the project in Debug and Release mode. But the linker script "fx3.ld" is not pre... Show More
AKS
USB superspeed peripherals
Hi, I am interfacing a qvga sensor to my FX3 board. configured it according to AN75779 reference doc. I traced the data on wireshark and as per the ca... Show More
leonkuang
USB superspeed peripherals
Dear, I have a UVC devcice, but I want to expand it as a composite usb device(UVC and HID device), because I need send some information (such as ascii... Show More
GrCa_1363456
USB superspeed peripherals
What is the difference between Infineon's two USB 2.0 two Storage interface SD2 parts, CYUSB2024-BZXI and CYUSB2025-BZXI? The FX3S webpage points to f... Show More
tayoc_1249536
USB superspeed peripherals
I am designing a circuit that uses the CYUSB3014 as a USB peripheral controller. I have  questions below. FX3 supports the 4 low-power modes(L1, L2, L... Show More
dablc_1191636
USB superspeed peripherals
Hi,    We are looking to use our FX3 device through Windows' built-in WinUSB driver.     We currently have the FX3 up and running as a "Cypress USB St... Show More
Prabhjot
USB superspeed peripherals
Hello Sir/Mam   We are planning to use the part CYUSB3014-BZXI in our design but the FPGA we are using only supports 1.5V I/O voltage level. SO could ... Show More