Hardware requirements for CYUSB3014 to support low power consumption mode

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
tayoc_1249536
Level 1
Level 1
10 sign-ins 5 questions asked 5 sign-ins

I am designing a circuit that uses the CYUSB3014 as a USB peripheral controller.

I have  questions below.

FX3 supports the 4 low-power modes(L1, L2, L3, L4). 

1.  If our circuit supports L1 and L2 low power modes, what are the recommended circuits?

2.  What are the hardware requirements to be able to enter L1 or L2 suspend mode or return to normal mode from these suspend modes at the command of the host PC?

 

Regards.

0 Likes
1 Solution
Biren_R
Moderator
Moderator
Moderator
First question asked First like given 250 sign-ins

Hello,

1.  If our circuit supports L1 and L2 low power modes, what are the recommended circuits?
-  Please follow This document AN70707 Topic 4 page no 7.

2.  What are the hardware requirements to be able to enter L1 or L2 suspend mode or return to normal mode from these suspend modes at the command of the host PC?

- For entry and exit for the mode you can refer to Link Table 6 on page 11.

Best Regards,
Biren

View solution in original post

0 Likes
1 Reply
Biren_R
Moderator
Moderator
Moderator
First question asked First like given 250 sign-ins

Hello,

1.  If our circuit supports L1 and L2 low power modes, what are the recommended circuits?
-  Please follow This document AN70707 Topic 4 page no 7.

2.  What are the hardware requirements to be able to enter L1 or L2 suspend mode or return to normal mode from these suspend modes at the command of the host PC?

- For entry and exit for the mode you can refer to Link Table 6 on page 11.

Best Regards,
Biren

0 Likes