USB low-full-high speed peripherals

cancel
Showing results for 
Search instead for 
Did you mean: 
Ask a question

Recent discussions

Sort by:
Mitchell_shen
USB low-full-high speed peripherals
We are use CY7C65211 on our system. But our system has low power requirement for USB ports. Does CY7C65211 meet below mention of LPM & BESL support? ... Show More
ubs1
USB low-full-high speed peripherals

Hi,

Any timer effect on data transfer bandwidth?.

zheng
USB low-full-high speed peripherals
你好,上面是我模仿an58764设计的CDC系统,我已经能正常通信。但是我仍然有一个问题没有解决,请帮忙解答,谢谢。 以前在这里提问过了,但是可能因为语言表达问题,没办法把自己的问题说清楚,以至于没有得到满意的答复。 https://community.infineon.com/t5/USB-low-full-high-speed/About-CDC-and-endpoint/m-p/325304#M10106... Show More
Aniket_
USB low-full-high speed peripherals
Hello,       As per KBA89285 I found these register address  0xE507 to 0xE50C holds unique id but I am getting same id for each  Cypress FX2LP control... Show More
anne_4609456
USB low-full-high speed peripherals
Hello. I need to program CY7C64315 using just USB connector (D+ and D-). Is it possible to connect ISSP DATA (P1_0) and ISSP CLOCK (P1_1) to USB line ... Show More
anne_4609456
USB low-full-high speed peripherals
Is there any USB microcontroller Full Speed at Cypress family where I can use the D+ and D- to program the firmware into the chip? I need just 4 digit... Show More
fzhang
USB low-full-high speed peripherals
Hi, We intended to configure CY7C65213  as self-powered mode. Other than the schematic connection shown below, the datasheet also says "Using the conf... Show More
DeCh_4514661
USB low-full-high speed peripherals
Hello Cypress, Could you please advise how I can identify SBC0/SBC1 of cy7c65216D if both of them are set as I2C? I am using linux C++ cyusbserial API... Show More
Xarzu
USB low-full-high speed peripherals
I am starting a new coding job with a new client.The problem I am having is that a lot of issues with namespaces that can not be found or maybe missin... Show More
Jerrywang0924
USB low-full-high speed peripherals

你好

我想在我的设计中使用2个端点。当我把 AN61345 - Source code ,FX2LP firmware中的SLAVE.C程序中的TD_init()函数中关于EP2的配置改为EP4时,传输的数据会发生错乱,这是什么原因呢?或者是我该参照哪些资料进行学习呢?