Anonymous
Not applicable
Jul 07, 2013
02:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 07, 2013
02:44 AM
Can CY7C68013A fifoadr[1:0] be configured by a register not by the pins.
I want to save two pins and the fifoadr[1:0] is always 10
that will never change.
2 Replies
Anonymous
Not applicable
Jul 12, 2013
05:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2013
05:12 AM
Hi,
No, that is not possible.
The endpoint can oly be selected by externally driving the FIFOADR pins. You can connect two output GPIO's to these two pins and control them through FX2LP firmware itself, if required.
Regards
Shashank
Anonymous
Not applicable
Jul 18, 2013
05:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 18, 2013
05:07 AM
Hi,
what did you mean by save two pins?
Regards,
Gayathri