Attachments are accessible only for community members.
Anonymous
Not applicable
Feb 17, 2012
02:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 17, 2012
02:56 AM
Hi, all,I am debugging GPIF FIFO read. I use the GPIF designer to generate the file gpif.c. I only use one waveform—FIFO Read. Other waveforms are not edited. Figure below is the waveform of FIFO Read. But after I added the gpif.c into project, called the GpifInit() in TD_Init(), without other code to trigger the GPIF, the firmware doesn’t respond to Cyconnsole.exe. so what’s the matter?
5 Replies
Anonymous
Not applicable
Feb 17, 2012
03:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 17, 2012
03:10 AM
I have sesolved the problem
Anonymous
Not applicable
Feb 17, 2012
12:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 17, 2012
12:08 PM
Hi,
Glad to know that the problem was resolved.
Cheers,
Gayathri
Anonymous
Not applicable
Nov 22, 2013
07:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 22, 2013
07:19 AM
I am having the same trouble where the console does not respond when I download the file onto the board. I am trying with an example off their website- FX2_to_extsyncFIFO GPIF Single Transactions. It uses GPIF to do single word transactions. How were you able to resolve this issue?
Thanks.
Anonymous
Not applicable
Nov 22, 2013
11:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 22, 2013
11:34 AM
I got it working. I had to change the default values of Code Range to 0x80-0x-0FFF and Xdata range to 0x1000 in BL51Locate tab in Options for Target.
Anonymous
Not applicable
Nov 27, 2013
11:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27, 2013
11:42 PM
Cool .. Thank you for sharing...