CyU3PDebugPrint and AN75779

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I'm working with AN75779.  I'd like to see the output from the various CyU3PDebugPrint() calls.  I'm not seeing much at the uart pins.  Is there some initialization I need to do?  What baud, parity, databits, stopbits, etc... am I looking for?

   

--Adam

0 Likes
4 Replies
Anonymous
Not applicable

CyU3PDebugPrint() works fine on my dev board, but not on my actual hardware.  At this point I'm going to assume it is a hardware problem and move on.

0 Likes
Anonymous
Not applicable

 Ok, looks like the dev board uses GPIO 48/49 for TX/RX.  My actual hardware has GPIO 55/56.  It's not obvious to me what i need to do in the code to switch them.

   

--Adam

Anonymous
Not applicable

 (Oh 115200 8N1, for anyone else searching the forums for the serial info)

lock attach
Attachments are accessible only for community members.
Anonymous
Not applicable
0 Likes