cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

JaMa_3208951
New Contributor

Hello,

I would like to configure the CYUSBS234 as an SPI slave and am trying to figure out if the RX/TX LEDs are on GPIO8 and GPIO9 like the datasheet says, or if they are on GPIO0 and GPIO1 like the configuration utility guide has them?

Thank you,

Jake

0 Likes
1 Solution
YatheeshD_36
Moderator
Moderator

Hello,

In the default configuration for CY7C65211/211A, the TXLED# and RXLED# is on GPIO_0 (pin 18) and GPIO_1 (pins 19).

This is configurable using the USB-Serial Configuration Utility.

pastedImage_1.png

Thanks,

Yatheesh

View solution in original post

0 Likes
1 Reply
YatheeshD_36
Moderator
Moderator

Hello,

In the default configuration for CY7C65211/211A, the TXLED# and RXLED# is on GPIO_0 (pin 18) and GPIO_1 (pins 19).

This is configurable using the USB-Serial Configuration Utility.

pastedImage_1.png

Thanks,

Yatheesh

View solution in original post

0 Likes