cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

JoLo_4180566
New Contributor II

Up until today, I've been able to program firmware onto my CCG3A through CC line as well as the Miniprog3. All of a sudden, I am getting the following error:

Program Finished at 11:39:04 AM                                |

                                                                | FAILED! Timeout of SROM polling. Lost communication with chip.

                                                                | Please, check the following items:

                                                                |  - the connection between the programmer and the PSoC;

                                                                |  - the correct programming protocol is selected;

                                                                |  - the correct connector option is selected.

I've checked all the settings but have not had any luck. I also tried the suggestion in the FAQ regarding reprogramming the CC bootloader but with the same results. Has anyone else had this problem? Did I somehow brick my main board?

0 Likes
1 Solution
JoLo_4180566
New Contributor II

I was finally able to program again. I don't know what caused it to not work as I didn't really change anything. It could be that I have a bad connection.

View solution in original post

0 Likes
1 Reply
JoLo_4180566
New Contributor II

I was finally able to program again. I don't know what caused it to not work as I didn't really change anything. It could be that I have a bad connection.

View solution in original post

0 Likes