cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

chch_3621411
New Contributor II

hello i developped power bank board thesign using the reference design now i'm looking for programmer device, afordable one like stlink v2, but i couldn't find good solution for cypress website or google.

0 Likes
1 Solution
YiZ_31
Moderator
Moderator

Hi,

According to the datasheet of CCG3PA:

CCG3PA family of devices can be programmed using the SWD interface. Cypress provides a programming kit (CY8CKIT-002 MiniProg3 Kit) called MiniProg3 and PSoC Programmer Software which can be used to program the flash as well as debug firmware. The flash is programmed by downloading the information from a hex file. This hex file is a binary file generated as an output of building the firmware project in PSoC Creator Software.  There are many third party programmers that support mass programming in a manufacturing environment.

Regards,

Yi

View solution in original post

0 Likes
1 Reply
YiZ_31
Moderator
Moderator

Hi,

According to the datasheet of CCG3PA:

CCG3PA family of devices can be programmed using the SWD interface. Cypress provides a programming kit (CY8CKIT-002 MiniProg3 Kit) called MiniProg3 and PSoC Programmer Software which can be used to program the flash as well as debug firmware. The flash is programmed by downloading the information from a hex file. This hex file is a binary file generated as an output of building the firmware project in PSoC Creator Software.  There are many third party programmers that support mass programming in a manufacturing environment.

Regards,

Yi

View solution in original post

0 Likes