cancel
Showing results for 
Search instead for 
Did you mean: 

TRAVEO™ T2G

Sentinel
New Contributor

When I read data from the Work Flash after erasing it i read random Data, is that normal?

0 Likes
1 Solution
Ashish
Moderator
Moderator

Hi,

Yes, what you observe is normal. You can only read from WorkFlash location, after it is programmed. This is by design. Reading from erased location is not possible (so if you try with debugger- it will result it random data). Normal flow is- erase then program then read. Below is screenshot from architecture TRM.

Ashish_0-1631862735601.png

 

Thanks,

Ashish

 

View solution in original post

1 Reply
Ashish
Moderator
Moderator

Hi,

Yes, what you observe is normal. You can only read from WorkFlash location, after it is programmed. This is by design. Reading from erased location is not possible (so if you try with debugger- it will result it random data). Normal flow is- erase then program then read. Below is screenshot from architecture TRM.

Ashish_0-1631862735601.png

 

Thanks,

Ashish

 

View solution in original post