- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have used the CYBT-343026's platform: Platform Files for CYBT-343026-EVAL – KBA221025
and i cannot get the Evaluation module to connect to the WICED Studio. The error i received says that it actively refused connection (basically no connection to EVAL).
i am trying to program either the uart.hex or the app/hello sensor application. Any advice?
Solved! Go to Solution.
- Labels:
-
ispn:40226:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could you refer to the following KBA to see if it can help: Programming an EZ-BT WICED Module – KBA223428
You may program the kit under a recover procedure.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could you refer to the following KBA to see if it can help: Programming an EZ-BT WICED Module – KBA223428
You may program the kit under a recover procedure.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you yes i have been using this KB however i did not look at a recovery procedure.
I will research that and see if i can recover it.
Thank you