- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Everyone
It seems that the host side FW will need to be updated as the version of EZ-Serial changes in the End-Customer's environment.
They would like to check the current version of EZ-Serial, can you tell me how to do it?
Thanks
Yang
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The FW version is in the boot message. Please check chapter 2.2 in the user guide about it:
You can also use the command system_query_firmware_version (/QFV, ID=2/6) to get the FW version. The detail information is in 7.2.2.6 of the user guide.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The FW version is in the boot message. Please check chapter 2.2 in the user guide about it:
You can also use the command system_query_firmware_version (/QFV, ID=2/6) to get the FW version. The detail information is in 7.2.2.6 of the user guide.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Owen
I confirmed that you have given the link.
I got the below message.
[The page cannot be found.]
Can you please check the link again.
Thanks
Yang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Owen
Can you please check the link again.
Thanks
Yang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Yang, please check if you can open this