Sep 20, 2021
10:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2021
10:06 PM
Hi
When sending commands via HCI UART, please tell me how to establish a connection → send commands.
・ Is this possible on WICED Studio? After the write status, the console cannot enter.
・ Which is more convenient to use makefile?
・ Is this possible on WICED Studio? After the write status, the console cannot enter.
・ Which is more convenient to use makefile?
Thanks,
Solved! Go to Solution.
Labels
- Labels:
-
WICED Studio Bluetooth
1 Solution
Sep 20, 2021
10:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2021
10:07 PM
Hi Misa
To use MBT.exe, see Prpject Explorer in WICED Studio.
See doc / Mannufactureing-Bluetooth-Test = tool.pdf. If it is continuous transmission, I think that 7 Continuous Transmit Test is applicable.
Thanks
1 Reply
Sep 20, 2021
10:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2021
10:07 PM
Hi Misa
To use MBT.exe, see Prpject Explorer in WICED Studio.
See doc / Mannufactureing-Bluetooth-Test = tool.pdf. If it is continuous transmission, I think that 7 Continuous Transmit Test is applicable.
Thanks