- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using the CYBT-213043-mesh-2 kit and programmed the HCI_loop_back test. I open the clientcontrol and looks like BR/EDR is disabled. I tried using FIND_ME app but no luck.
I am looking to connect the CYBT-213043 to external devices making it discoverable for other devices to connect. Also, please let me know how to enable the diagnostic mode on this board.
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYBT-213043 mesh kit is aimed for the mesh application. If you need to run general BLE application, it's better to use the CYBT-213043-EVAL kit.
To run a general BLE demo on the CYBT-213043-MESH kit, you can choose the CYBT-213043-EVAL kit when you select the bsp on MTB. Then create a LE Find Me demo and download it to you mesh kit. You can find the "Find Me Target" on your phone with a BLE app.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYBT-213043 mesh kit is aimed for the mesh application. If you need to run general BLE application, it's better to use the CYBT-213043-EVAL kit.
To run a general BLE demo on the CYBT-213043-MESH kit, you can choose the CYBT-213043-EVAL kit when you select the bsp on MTB. Then create a LE Find Me demo and download it to you mesh kit. You can find the "Find Me Target" on your phone with a BLE app.