- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is it possible to debug a CYW20736S on custom board with a JLINK?
I see nothing in the datasheet (hardware recommandation) ? What J-Link is recommended ?
Thanks
Solved! Go to Solution.
- Labels:
-
Debug
-
ispn:36156:1:0
-
l1:3966:1:0
-
l2:3982:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, a document that maps the pins for the SOC to the debugger does not exist. Only the Help Article noted above which uses the TAG3 board. The schematic for the TAG3 board is in the Hardware User Guide (SDK 2.x and TAG3 Board)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Debugging on this device is limited.
The only debugger I'm aware works/tested is described here: WICED Smart J-Link Debugger
This post discusses alternatives: Segger J-Link debugger alternative
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks
Do you have an AN to know witch PIN of the BCM20736S is used to plug the J-Link debugger?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, a document that maps the pins for the SOC to the debugger does not exist. Only the Help Article noted above which uses the TAG3 board. The schematic for the TAG3 board is in the Hardware User Guide (SDK 2.x and TAG3 Board)