- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
They are evaluating REFWLCTX15WC1 by connecting Tera Term.
Then, I have questions.
Could you please tell me the meaning of the following parameters?
・PLOSS_THRES = 325mW
・PLOSS = -152mW
・PTx_calib = 3175mW
・Threshold = 326mW
・DIE TEMP
REFWLCTX15WC1にTera Termを接続して評価をしています。
そこで質問があります。
下記パラメータの意味をご教示ねがいますか。
・PLOSS_THRES = 325mW
・PLOSS = -152mW
・PTx_calib = 3175 mW
・Threshold = 326 mW
・DIE TEMP
Best regards,
MS
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please find the definitions below:
PTx_calib - Calibrated transmitter power(See equation 6 in AN234970)
NTC TEMP = Temperature sensor value in °C(External NTC temperature sensor)
DIE_TEMP = Temperature sensor value in °C(We have a Temperature sensor in the Die)
PLOSS_THRES - FO detection Power loss Threshold value set in the utility
Threshold - Corrected Threshold based on losses for that particular receiver
PLOSS - Actual power loss calculated
Thanks,
Ajeeth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please find the definitions below:
PTx_calib - Calibrated transmitter power(See equation 6 in AN234970)
NTC TEMP = Temperature sensor value in °C(External NTC temperature sensor)
DIE_TEMP = Temperature sensor value in °C(We have a Temperature sensor in the Die)
PLOSS_THRES - FO detection Power loss Threshold value set in the utility
Threshold - Corrected Threshold based on losses for that particular receiver
PLOSS - Actual power loss calculated
Thanks,
Ajeeth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ajeeth-san,
Thank you for your prompt response.
Please let me know about the parameters below.
・Threshold = 326mW
・DIE TEMP = 28℃
Best regards,
MS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
DIE_TEMP = Temperature sensor value in °C(We have a Temperature sensor in the Die)
PLOSS_THRES - FO detection Power loss Threshold value set in the utility
Threshold - Corrected Threshold based on losses for that particular receiver
Thanks,
Ajeeth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ajeeth-san,
Thank you for your detailed explanation.
Best regards,
MS