- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
I wish to build a battery charger where I can cotrol the output voltage & current to give a total of 300VA.
In that I want-
1. Current control &
2. Voltage control
totalling to 300VA.
While charging the battery I want <=85% charging should be a boost charging (rapid charging with high current) & the next 15% should be a trikle charging (continuous charging with low current).
Also I want the feature of Auto turn-off at full charge & setting a minimum limit to start the charging.
Please guide me on this.
Thanks & Regards-
Amit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Amit,
I believe the following Application Note would be a good starter:
AN73468 - PSoC® 3 and PSoC 5LP - Single-Cell Lithium-Ion (Li-ion) Battery Charger
Link: http://www.cypress.com/?rID=58095
Regards
PSoC Wonders!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello sir, thanks for considering. I will definitely go through the suggestions & see how much would it help.
Regards-
Amit