- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
Question: After installing Creator, what do I have to do to get the IDE to Find a Kit or a Solution?
I have clicked the refresh button next to the text (see subject line) as well as the refresh button found above the Component Catalog on an open schematic page. What can I load or install that will be recognized by the IDE? CY8CKIT-001 is the only PSoC3 (or PSoC5) kit I have at the moment.
Thanks
Tim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm sure others can elaborate on this, but any PSoC 3 or PSoC 5 kit you have should come with a CD. Install the kit SW, and then the kit information should appear on the Start page. If not immediately, then click that refresh button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry about the delay.... This DID work. What I had not tried was navigating into the CD and loading the KIT SOFTWARE on its own. I had just assumed (underline that last word) that doing the install (of the Creator software) would take care of everything.
My bad.
Tim