- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was working on a project happily for an hour or so writing code and testing with the MiniProg3.
Now for some reason? The brakpoints cannot be set. When I attempt to run the code the breakpoints change from solid to just a circle outline.
Once again, I have am not aware of making any changes to settings, only the code I am compiling in main.
The target is PSOC 4 this time. Is there some hidden gotcha I need to read about this too?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, I found it. My mistake. Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Despite from "How did you find out" my question is :"What did you do?"
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Crystalball guess: some forgotten breakpoints in already closed files (and in places that were not reached at time of testing). Happened to me before 😞
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, exactly.
Silly mistake, not an actual break point but an infinite for loop I had not removed ... for(;;)