- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi there! Hope you're doing well. I'm new to the whole Psoc 6 environment.
I am currently working on a project that requires me to transfer data acquired from the ADC and send it to an ESP32 via BLE.
Till now I have finished the ADC part. And have done a lot of examples on the BLE (Glucose meter, Heart rate monitor, Thermometer...).
I am now stuck making a BLE server that works. I am trying to use the CE222046_GATT_Out example as previous forum responders have suggested, in order to create a custom service, but I am facing the following issue:
- After connecting to the GATT Out BLE server with NRF connect, I am getting disconnected when I try to enable notifications from the client side via the NRF connect app.
Also some important info:
- The CE222046_GATT_Out example is being used.
- I am using the CYBLE-416045-02 Psoc 6 prototyping board.
- I am using Psoc creator.
Can someone tell me what am I missing? It's been a while I'm stuck at this stage.
Thank you for your support 🙂
Solved! Go to Solution.
- Labels:
-
PSoC 6 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the attached Modified project.
Please let me know if this helps.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Could you please share your project for checking at our end ?
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Project has been uploaded
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content