- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using the CapSense Tuner I2C project but I cannot get any touch detection on my board. The I2C connection is ok and it is reading 154pkts/s. The graph in the tuner always reads no activity. When I load my own application with SmartSense Full Auto Tune, I can detect slider and button press but the accuracy is bad. If I try to enable Full Auto Tune in the Tuner project, it fails on connection and says checksum mismatch. Does anyone know what I should change in the tuner project so I can see some activity?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which CapSense Tuner I2C project and kit are you using?
Manual tuning may require extra tuning according to different kits or customer boards.
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I got the tuner to work on my own project using full auto tune. I'm still not sure why I see 0 activity using the I2C demo project. If the results of auto tune aren't good, is there a guide for modifying the tuning settings?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which CapSense Tuner I2C project and kit are you using?
Manual tuning may require extra tuning according to different kits or customer boards.
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using CE222827_PSoC6_CapSense_Tuner with project name CapSense_Tuner_EZI2C01 from the examples installed in PSoC Creator 4.2. The main_cm4.c header version says 1.10. I will work with my local FAE for manual tuning. Thanks.