- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I just try to test the I2C followed the step of PSoC 6 101: Lesson 2-3a Basic I2C Implementation.
In the panel, I just can see the com port, but no Kitprog2 on the list.
I check the manual, there is the introduction of The KitProg2 can function as a USB-I2C bridge, so it supposes to work.
What's the problem?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It looks the kitprog2 port is not shown in control panel port list. Please check the device manager in your platform whether kitprog2 is shown, just like attached capture(under 'Ports' list).
If not shown, please check if the correct mode is on by SW3 on the board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please make sure you have select the 'Protocol' as 'I2C' in the control panel GUI. otherwise, I2C interface would not show.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
But the protocol I2C is not selectable, thx
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It looks the kitprog2 port is not shown in control panel port list. Please check the device manager in your platform whether kitprog2 is shown, just like attached capture(under 'Ports' list).
If not shown, please check if the correct mode is on by SW3 on the board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, the problem is the SW3, thx