i'm trying to do some test with designer5 in chip mode.
led blinking , pwm 8 controled led and at the end, ezi2c in slave mode.
i have assigned pins 7 ^ 5 in the properties of the control as sda ^ scl.
The intention was to controll some variables using
the Bridge control panel.
in this last test, after program the FTMF the blue led on the FTPC stop flashing , and is
not possible to program again the FTMF. if i remove the module, the blue led blink again.. if i conect the FTMF the FTPC appears as disconected.
There is some way to recover from this point ?
thankyou
