Anonymous
Not applicable
Jun 12, 2018
12:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2018
12:18 AM
I am using the device PSOC 5LP CYC8C5868AXI-LP035, I want to use CAN interface..for that instead of going with CAN module from Cypress I would like to use CAN transceiver IC TJ1040 from NXP..may I know which pins of controller I have to use.
Solved! Go to Solution.
Labels
1 Solution
Jun 12, 2018
11:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2018
11:16 PM
Hi,
You could use any pin in the controller. Please refer to http://www.cypress.com/file/45906/download (page 47).
Thanks,
Shanmathi
1 Reply
Jun 12, 2018
11:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2018
11:16 PM
Hi,
You could use any pin in the controller. Please refer to http://www.cypress.com/file/45906/download (page 47).
Thanks,
Shanmathi