PSoC™ 5, 3 & 1 Forum Discussions

Is there a way to use the CY8CKIT-009A PSoC3 module with the Miniprog3 without having to use the CY8CKIT-001 kit?

Can anyone help me to configure a pin as digital output in PSoC 5.4? I need to set up the register. When I first run the program, the output must be "1" and then when I press a key it goes to "0". I've tried to set up the pin using the chip editor, but its not working properly.

Hello all,

I am looking for a good reference/sample for Alternate Active mode in either PSoC3 or PSoC5LP, such as " Using Sleep and Hibernate modes in PSoC®  3 – AN66083" for Sleep mode. Anybody came across such do post the link here.

Thaks in advance.

Anuradha.

The CAN Controller customizer does not allow selecting more than one mailbox IRQ in a linked group.  Does that mean that you cannot trigger an IRQ for each received message that is received by the linked group of mailboxes?  What would happen if I unlinked them and manually set the configurations exactly the same?  Would this cause some conflict when a message comes in that matches the filters of multiple mailboxes?

 I would like to suggest a feature that would allow multiple configurations to be set up through the customizer.  In an automotive CAN application, it is required to try 2 different baud rates and 11 bit and 29 bit ID format.  It is difficult to work with the CAN_RX_CFG and CAN_TX_CFG structs to reinitialize the CAN mailboxes with different values for switching between the 11 and 29 bit ID formats.

 Hi guys,

I am using an adc and USBFS (not USBUART) in a project. The adc output is being displayed on the lcd and simultaneously also being loaded into the endpoint of usb. I have configured usbfs for bulk transfer with endpoint 1 set for IN mode.

However on execution, the transfer is not taking place and the program gets stuck at this command:

while(USBFS_GetEPState(IN_EP)!=USBFS_IN_BUFFER_EMPTY);

I have attached my project file under the folder name "proj3".

I would be grateful for any suggestions quickly.

 Hello,

Does the Enable Vref/Vssa option in the ADC's Common tab allow us to connect a variable reference in PSoC schematic (rather than allocating a special pin to acquire an external Vref?