Jul 03, 2016
11:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2016
11:47 PM
I want to sense voltage between 0 to 10 V from ADC with Circuit Divider??
My question is that where i connect my GND terminal of 0 to 10 V input with cypress??
Labels
- Labels:
-
PSoC 1
3 Replies
Jul 03, 2016
11:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2016
11:55 PM
Your sensing voltage source and the PSoC board need to have a common ground GND.
Bob
Jul 04, 2016
12:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2016
12:36 AM
how can i do it??
may i connect 0 to 10 V GND with cypress GND??
or other psoc resource??
Jul 04, 2016
02:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2016
02:02 AM
may i connect 0 to 10 V GND with cypress GND??
Usually: Yes
But you may use a multimeter to see if there is a potential differenge between those two GND points
Bob