Showing results for 
Search instead for 
Did you mean: 

PSoC™ 5, 3 & 1

Not applicable

Hi everyone,


I have a PSoC 5LP on a custom board, connected to my laptop through a USB cable. The drivers are installed properly, and the board is showing up in the device manager and bootloader host, connected to COM3. 


          However      it's not being picked up when I try to enter Debug mode. The target screen is blank and I get a "Port Acquire Failed" message, telling me to check the cable connections and to close any other applications that might be using the port.


I've verified that I'm using the correct device from the Device Selector, I've tried rebooting, using different ports and cables, changing the baud rate, reinstalling PSoC creator and have even tried it on other computers with no luck so far.


I don't know what I'm doing wrong, but any help would be greatly appreciated. Thanks!

3 Replies