Anonymous
Not applicable
Oct 15, 2018
02:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 15, 2018
02:25 AM
Hello, I am trying to control the speed of a brushless DC motor using an external electronic speed controller. The speed is determined by a signal from an RC device which I have been able to configure correctly to read the input and generate a measured pulse width (from 1ms to 2ms), using a timer configured for input capture. My only issue is outputting a signal to the ESC (requiring an 8kHz PWM signal) to drive the motor. I have attached part of my project for scrutiny and advise. Thank you.
Regards,
Leslie
Labels
1 Reply
Oct 15, 2018
10:49 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 15, 2018
10:49 PM
Hello Leslie,
Could you please let me know the actual issue you are facing with the PWM? What is the problem you are facing when you try to output 8KHz PWM signal ?
Best Regards,
VRS