Attachments are accessible only for community members.
Anonymous
Not applicable
Nov 16, 2011
06:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2011
06:07 AM
I've compiled the UART_Rx.cywrk example in the CY8CKIT-001 development kit and have been unable to get it working while sending characters over RS232 using Labview. I've send "LCD". It shown double alpla and japan character. Even I use hyperterminal also same. Any ideas what might be causing the problem?? Thanks.
Labels
- Labels:
-
PSoC 5LP
3 Replies
Anonymous
Not applicable
Nov 16, 2011
09:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2011
09:56 AM
Are the baud rates equal?
Anonymous
Not applicable
Nov 16, 2011
04:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2011
04:47 PM
Do you have receiver echo to the transmitter?
Anonymous
Not applicable
Nov 22, 2011
11:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 22, 2011
11:34 PM
This could possibly be due to Baudrate mismatch as highlighted in the post earlier. Please ensure that the baud set on the labview module matches with the baud set in the PSoC project.