cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC™ 4

Anonymous
Not applicable

Hello,

   

I use the device Cy8C4013LQI.

   

I must disable all components for power saving.
So I followed the instruction to change the debug interface to from SWD to GPIO.

   

Programming should always be possible.

   

But after download the firmware I can not connect the device anymore.
I use Segger-Jlink with the newest Firmware and software.

Here I found a similar problem.

   

http://forum.segger.com/index.php?page=Thread&threadID=2945

   

There are speaking about the version p, but in the download area only available version j.

   

So - how can I fix the problem? Now I blocked 3 prototypes.

0 Likes
2 Replies
rola_264706
Honored Contributor II

Cypress doesn't support this software for programming the device and recommends Psoc Creator programming.  I would suggest that you open a case with Cypress to see if they have a solution.

0 Likes
Anonymous
Not applicable

Yes, I will open a new case.
I think, the problem is by Segger. Because the same problem was on a other type of Chips (BLE).
The reason why we use the Segger is, that we have for programming a big platform of severall industrial programmer from Segger and must use them for production programming.

0 Likes