PSoC™ 4 Forum Discussions
text.format{('custom.tabs.no.results')}
Pleasehelp me understand the op-amp datasheet of psoc-4
The datasheet of PSoC-4 Op-Amp reads:
[1] I_OUT_HI = 10mA (minimum)
max and typ are not specified. What is the meaning of minimum 10mA?
[2] V_OUT @ I_Load 10mA = 0.5V min and Vdda - 0.5V max
What is the meaning of this? The output should not fall below 0.5V?
[3] It written.... "Low resistive connections are made from the
Opamp to three select pins to provide optimal performance."
What's the meaning of this? Does it mean that only three pins of the GPIO can work faithfully with the op-amp? Which three pins?
Show Lessproblems sending data of adc and uart :
I want to use STOP input in PWM mode. Datasheet says that STOP should be available in all modes, but it is not visible.
How can I make use of this input?
Show LessHi,
I am having some issues with the emulated EEPROM. I have set it up as a set location in flash memory 0x1a00 using the linker and MYSECTION params. However, everytime I reprogramm the device it clears all the flash memory. How can I ensure it does not do this when I am reprogramming it?
I can attach a project if that would help. I am using the PSoC4 prototyping kit.
Regards,
Lance
Show LessHi all,
I completed my project human detection using IR proximity sensor in PSoC. I used GSM module also. I want to calculate power consumed by chip while working. From where I can calculate the power cunsumed by chip...????
Actually I want to compare it with power consumed by other devices. Please give me suggestions.
Thanks.
Show LessNot sure if everyone has seen this -
"This spreadsheet is a basic tool for obtaining a gross estimate of power consumption using
PSoC 3 ES3 and PSoC5 ES1."
Hopefully will be done for PSOC 4 ?
Regards, Dana.
Show LessHello everyone I am a student of the university district of Colombia and in my graduation project I am using a psoc 4 prototype, I need to handle a GLCD 128 * 64 my question is there any library for psoc 4 ??? because all I've found are for psoc 5, and the truth I do not have much budget thank you very much ..
Show LessHi All,
I want to use a Counter component as 32Bit Timer in PSoC 4 BLE and I am connecting a clock source to counter clock and I am getting following warning:
Warning-1366: Setup time violation found in a path from clock ( CyHFCLK ) to clock ( Clock_1 ).
I am getting this problem when the IMO is higher than 24 MHz. There is no warning for 24 MHz IMO.
So, what is the problem
Show LessHi All !
I am quite near to complete the GSM Project. I am not getting desired results as of now. The project which I designed, sends message to Cellular Phone when a push button is pressed. It receives message from Celllular Phone also. It displays it on LCD. Currently I am facing a problem in which I am able to send the message as many times as I press the pushbutton, but not able to receive it and display it on LCD once I send a message priorly. Please find attached my project. I request all to contribute, so we can make a GSM Module for PSoC4.
Regards
Shaunak
Show Lesshi,
While building the project i m getting this error
Error: mpr.M0014: Resource limit: Maximum number of UDB Datapath Cells exceeded (max=4, needed=5). (App=cydsfit)
find the attached image and guide me for the solution
Show Less