Anonymous
Not applicable
Nov 11, 2015
10:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2015
10:57 AM
I am using two TCPWM to provide two PWM signal outputs to extrernal circuits.
What is the lowest power mode I can enter, while maintaining these two outputs active? i.e. continue to pulse at their assigned freq and Duty cycle.
It looks like "Sleep" is the lowest I can go. Can I go lower power than that?
Thanks
Labels
- Labels:
-
BLE
2 Replies
Nov 11, 2015
11:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2015
11:26 AM
No, you cannot. The only exception is when the PWM frequency is very low using deep-sleep and wakeup at the desired moment to switch a pin.
Bob
Nov 12, 2015
07:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 12, 2015
07:32 AM
That's what I thought, thanks Bob!