Announcements
Community Announcement : Welcome to the NEW Cypress Developer Community.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4

YuMa_1534086
Contributor

Hello Cypress.

Below is description of MBR3 design guide.

Document explains that recommended guard sensor thickness is 2mm.

pastedImage_0.png

Which part of guard sensor does this description explain?

Does this “thickness” define actual trace thickness(“A” of below figure)?

Or does this “thickness” define width length of guard sensor(“B” of below figure)?

pastedImage_1.png

Best Regards.

Yutaka Matsubara

0 Likes
1 Solution
BragadeeshV
Moderator
Moderator

Hello,

The thickness here refers to the width length of the guard sensor.

Regards,

Bragadeesh

Regards,
Bragadeesh

View solution in original post

0 Likes
3 Replies
BragadeeshV
Moderator
Moderator

Hello,

The thickness here refers to the width length of the guard sensor.

Regards,

Bragadeesh

Regards,
Bragadeesh

View solution in original post

0 Likes
YuMa_1534086
Contributor

Bragadeesh-san.

Thank you for your answer.

Why did cypress use the word of “thickness” in explaining the specifications of guard sensor width length?

I think that many customers are confused by the word of “thickness”.

I think that it is difficult to associate sensor width with the word of “thickness”.

Best Regards.

Yutaka Matsubara

0 Likes
Anonymous
Not applicable

Not all collegues at Cypress are native english language Speakers. I'm also not. So sometimes, we have a bit a misunderstanding, right?

Best regards!

Jurgen.

0 Likes