- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Cypress.
Below is description of MBR3 design guide.
Document explains that recommended guard sensor thickness is 2mm.
Which part of guard sensor does this description explain?
Does this “thickness” define actual trace thickness(“A” of below figure)?
Or does this “thickness” define width length of guard sensor(“B” of below figure)?
Best Regards.
Yutaka Matsubara
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The thickness here refers to the width length of the guard sensor.
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The thickness here refers to the width length of the guard sensor.
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bragadeesh-san.
Thank you for your answer.
Why did cypress use the word of “thickness” in explaining the specifications of guard sensor width length?
I think that many customers are confused by the word of “thickness”.
I think that it is difficult to associate sensor width with the word of “thickness”.
Best Regards.
Yutaka Matsubara
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not all collegues at Cypress are native english language Speakers. I'm also not. So sometimes, we have a bit a misunderstanding, right?
Best regards!
Jurgen.