- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i want to make program header for program my external project which is based on psoc-4.
i have a miniprog3.
till now i am using psoc-4 kit. so dont need header.
can you tell me which pins i have to connect miniprog3 to psoc-4(cy8c4245axi-483) for external programming.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All five of the SWD pins should be connected:
VTARG, GND, XRES, SCLK, SDAT
The specific pin-out will vary based on the package you pick, but here is the datasheet to find the pin-out for the different packages:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi e.pratt_1639216,
Thanks for Reply.
i can not open that file which you suggest me.
can you send me in attachment??
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you google the search terms "cy8c4245axi-483 datasheet", it should come up with the page hit: http://www.cypress.com/part/cy8c4245axi-483
Which has links to the datasheets in English,Chinese, and Japanese I believe;
I will also attach the file here if I can
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you tell me which chip package you are using? (TQFP-44 pin, QFN, SSOP, TQFP-48 pin)
Do you have the chip powered through your PCB board? Or are you powering it using the miniprog3?
If powering it using the miniprog3, make sure your settings are correct.
Are you using the Psoc Creator to program? Or the Psoc Programmer? (The Psoc Programmer has a gui to make sure you setup the settings correectly)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi e.pratt_1639216,
i am using TQFP-44 pin package.
and i am powering it using miniprog3.
i tried with both psoc creator and psoc programmer.
can you give me right step and settings for programming??