- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can not program the devices CY8CKIT-49-41xx and 49-42xxx, the message is "
01:50:46 PM - Communication port reported error 'Unable to read data from the target device'."
If I have previously programmed devices, but after the upgrade is impossible.
Nor do I appear ports in PSOC Programer and I deleted and reinstalled the driver devices.
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fixed install driver and PSoC 3 functions as always, great.
(Possibly Problem for the latest update of W10, yesterday morning).
Thank you.
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It would be good to reinstall the Driver of the Usb-serial (
http://www.cypress.com/documentation/software-and-drivers/usb-serial-software-development-kit
USB-Serial Bridge Controller ) and ensure that the communication speed is correct (115200) I recommend this video
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much for the information, the video you'd already displayed.
Regards.