- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
About MBR3, when are Capsense Parameters calculated in SmartSense?
About PSoC, timings of calculation is described below table
at "PSoC® 4 and PSoC 6 MCU CapSense® Design Guide".
The customer wants similar imformation.
Best Regards,
Inoue
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Junichi,
MBR3 and PSoC 4 uses the same algorithm for Smart Sense and hence this data applies to MBR3 also.
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Junichi,
MBR3 and PSoC 4 uses the same algorithm for Smart Sense and hence this data applies to MBR3 also.
Regards,
Bragadeesh
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Bragadeesh,
Thank uou for your answer.
I understood these timing of MBR3 is the same as "Full Auto tune-Mode".
Is it correct?
Best Regards,
Inoue
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
MBR3 allows you to set finger threshold manually if automatic thresholding is diabled. Hence, it does both things.
Regards,
Bragadeesh
Bragadeesh