cancel
Showing results for 
Search instead for 
Did you mean: 

Other Technologies General

DaRa_4676996
New Contributor

Hi,
My name  is Dan Radut and I started recently a project that is supposed to use a PSoC 4200L.

I have designed the schematic below that turns alternatively ON/OFF the output signal Gen_ON_OFFn
each time when pressing the Switch2.

Please could someone explain why the Build issues this error message when the output digital pin
Gen _ON_OFFn is attached to the TFF output:

mkdepend: error:  cannot open ""

The command 'mkdepend' failed with exit code '1'.

This is the schematic:

pastedImage_0.png

The pin assignments are:

SW2                      P0[7]
Gen_ON_OFFn    P5[4]
UART:rx                P4[0]
UART:tx                P4[1]

Your comments and help will be highly appreciated,

Dan Radut

0 Likes
1 Solution
VenkataD_41
Moderator
Moderator

Hi Dan,

I am using the latest version of PSoC Creator i.e. PSoC Creator 4.3 at my side. I am not able to see any issue during build process. The build is successful with your schematic. Please check the attached project at your side too.

Thanks

Ganesh

View solution in original post

0 Likes
2 Replies
VenkataD_41
Moderator
Moderator

Hi Dan,

I am using the latest version of PSoC Creator i.e. PSoC Creator 4.3 at my side. I am not able to see any issue during build process. The build is successful with your schematic. Please check the attached project at your side too.

Thanks

Ganesh

View solution in original post

0 Likes
DaRa_4676996
New Contributor

Hi Ganesh,

With your help I found the cause of this error message: the long path to the project folder location.

Thank you for your time and help,
Dan

0 Likes