Nor Flash Forum Discussions
I am using S25FL064L with CY8C624ABZI.
I create a project "QSPI_Flash_Read_Write" and change the target to S25FL064L and code works.
Now i want to let S25FL064L go into deep power down (which is about 2uA in datasheet) but don't know what to do.
How do i let S25FL064L go into deep power down with using "serial-flash" library?
Or, what library should i used? Is there any example about read, write and deep power down?
Hello,
Does infineon provide HDL for their NOR flash s25fl256 (S25FL256SAGMFI001) ?
Thank you,
James
Show LessHELLO,
因为S29GL512P11TFI010停产换成S29GL512T10TFI010,原来的简化码S99-50289对应停产的S29GL512P11TFI010,然后改成对应的替代型号S29GL512T10TFI010吧?
请确认S99-50289是否对应S29GL512P11TFI010。
BR,
兰尼
lanny@smartecelec.com,
Show LessPlease provide Datasheet for CYRS17B512 Radiation hardened Flash device.
Hello,
Could you tell us the maximum PCB trace routing length for address lines , Data lines & Control signals?
By referring the 'Infineon-AN216200_Infineon_Non-Burst-Mode_Parallel_NOR_Flash_Memory_Layout_Guide_for_PCBs-ApplicationNotes-v02_00-EN.pdf', it is understand that overall mismatch within group shall be +/- 500mil. What will be the allowable maximum PCB trace length (considering operating in high speed condition)?
Show LessTo what extent is S25FL256L Flash memory Opcode compatibile with EPCQ standard & Intel ASMI parallel intel IP?
In the S25FL256L datasheet, some opcode are not compatible/ missing.
Greg
Show LessIt is described on page 47 of the above flash ROM data sheet "Document Number: 002-01522 Rev. * B".
According to Figure 9.1 Write Buffer Programming Operation
When DQ5 = 1, it is written to read DQ15-DQ0 again. Is a delay necessary?
MPN: S29GL256N10TFI010
Hi Team,
We are using NOR Flash ( S70GL02GS12FHIV20 ) interfaced with IGLOO2 FPGA for our memory storage application.
Kindly provide the layout guidelines to place and route the memory IC.
Show LessWhat are the thermal resistances junction-to-ambient, junction-to-case, junction-to-board, etc. of S29PL127J70BFI040 ?
What is absolute maximum junction temperature ?