cancel
Showing results for 
Search instead for 
Did you mean: 

ModusToolbox General

YiCh_4772066
New Contributor

I installed the ModusToolbox and offline package follow the ModusToolbox Installation Guide and have set the system variable to specify the path to Tools.

But  create an example Hellow World have the follow error

Log file(s) for this session are stored at: D:\Users\HAYMAN~1\AppData\Local\Temp\Logs6614219753211729983

Opening project creator from D:/Tool/ModusToolbox/tools_2.1/project-creator/project-creator

Importing Hello_World (1/1) ...

Error creating Eclipse launch configurations: Makefile:163: *** Unable to find any of the available CY_TOOLS_PATHS -- D:\Tool\ModusToolbox\tools_2.1 .  Stop.

Done.

Unable to find configurator information: Makefile:163: *** Unable to find any of the available CY_TOOLS_PATHS -- D:\Tool\ModusToolbox\tools_2.1 .  Stop.

Phlease help, TKS!

0 Likes
1 Solution
Charles_Lai
Moderator
Moderator

Hi,

Two more suggestions:

  • a) Try to completely uninstall and then reinstall ModusToolbox to make sure your ModusToolbox and all its components are presenting.
  • b) Their is also a macro / variable named "CY_TOOLS_PATHS" in your project's makefile, which is located at the root of your project. You can check or alter it, to help you analyze the issue.

Best regards

View solution in original post

0 Likes
3 Replies
Kenshow
Esteemed Contributor

Hi,

The message is that CY_TOOLS_PATHS is not available, so if you think about it normally, you doubt this path or path setting.

It seems that there are similar posts in the past, so it is recommended to search by CDC.

For example, how about the following?

 

Re: ModusToolbox on Linux HelloWorld example

Regards,

Kenshow

0 Likes
Charles_Lai
Moderator
Moderator

Hi,

Two more suggestions:

  • a) Try to completely uninstall and then reinstall ModusToolbox to make sure your ModusToolbox and all its components are presenting.
  • b) Their is also a macro / variable named "CY_TOOLS_PATHS" in your project's makefile, which is located at the root of your project. You can check or alter it, to help you analyze the issue.

Best regards

View solution in original post

0 Likes
YiCh_4772066
New Contributor

I modify the  "CY_TOOLS_PATHS"  in makefile , Then the problem solved. Thank you!

0 Likes