Legacy microcontrollers Forum Discussions
Dear all,
I use this microcontroller and it's actually out of stock.
If you know a distributor or a broker which have some stock it will be very helpfull?
Or in an other way if anybody know if we can find pin to pin compatibility with another model?
Thank you very much for your help
Show Less
Hi
I want to use my J-link plus with my FM4-176L-S6E2GM boards. I dont want to use CMSIS-DAP either onboard or segger. To use the j-link I need to set the Program Counter to the DAP bootloader exit address ? Which I cannot figure out.
Please help if you know
Thanks developerR
Show LessHi, I'm new to the Infineon microcontroller family, presently there is a requirement to do the development with the Xc836 microcontroller.
can you please suggest, how to start with, which IDE I have to use, and what tools are required for the programming?
Show LessWe can use excel file to input motor parameter and compile the FOC motor driving project.
We got .hex file for downloading to MCU XC878.
Our application board can start motor as open loop.
Then motor has a little vibration and fail for running. (I think it cannot get in close loop control)
My question:
We need to adjust some parameter on excel file right?
We don't have experience for tuning XC878 motor drive.
If you have experience, could you guide us step-by-step ?
Thank you.
Best Regards,
iamten Show Less
I'm new to the Infineon. I'm using XC836 8-bit microcontroller, can anyone suggest the, which IDE and debuggers I have to use for above mentioned microcontroller
Show LessHi,
I was writing data to the main Flash using 16bit, and there was a discrepancy between the data read and the data written. I used the reference routine to simplify the code that could cause problems.
Best regards,
Thanks
Show LessHi Dear,
We used to use CY96F348HSCPQC-GSE2 and CY96F348HSBPQCR-GSE2 for our controller, now we need produce some controllers for our customer, and they are both obsolete part now, when I check discontinued product function for them, Infineon official website shows both of these 2 parts don't have replacement, could you please advise some solution or suggest any simillar part(s) for thess 2 parts,
Many thanks with kind regards.
Steven Song
Show LessHi. I need a tool for read and write this MCU. INFINEON sak-c505ca-4em
Please let me know the details.
I'm trying to figure out how to erase PFlash1 sector 0.
Give me a hint please should I use the following settings?
ST = 0xA0000000;
SA = 0xA0800000; // PFlash1 S0?
Erase Sector
Calling:
• ST 5554 H , xxAA H
• ST AAA8 H , xx55 H
• ST 5554 H , xx80 H
• ST 5554 H , xxAA H
• ST AAA8 H , xx55 H
• ST SA, xx30 H
Function:
The sector “SA” is erased.
Show Less
could you please answer the following question we received via social media?
Question: Why DC to DC? What's the use case?
Here is the link to our post: https://www.facebook.com/345383962211058/posts/5777023409047059/
Show Less