- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We have our PCB based on ‘Cypress CY95F698KPMC1-G-UNE2’ MCU, but for some reason we can’t flash the operation file and debug it (we use a laptop with windows 7, SOFTUNE IDE version 30L35 and 2146-07-E debugger).
The problem is that when I'm trying enter debug mode in the softune, I get a message that the driver for the debuger has not been found, although the drivers are installed in the laptop and I can see that the debugger is recognized correctly in the devide manger of the windows, when I plug it.
I would be happy if someone would help me with this.
Thanks alot
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Are you using the Windows7 USB driver - https://www.cypress.com/documentation/software-and-drivers/windows-7-operation-released-softune-prod...
And the below manuals might be helpful for you.
https://www.cypress.com/file/367586/download
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Are you using the Windows7 USB driver - https://www.cypress.com/documentation/software-and-drivers/windows-7-operation-released-softune-prod...
And the below manuals might be helpful for you.
https://www.cypress.com/file/367586/download