Unable to Connect to PSoC 64 MCU after "Erase Chip" Operation in J-Flash Tool - KBA232539
Employee
Feb 18, 2021
05:59 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Feb 18, 2021
05:59 AM
Author: VitaS_81 Version: **
Background: This issue occurs because during the “Erase Chip" operation, the whole flash of device is erased including the Cypress Secure Bootloader allocated in the main flash area, which is not protected from erasing.
Solution: Use the "Erase Sectors" operation in J-Flash tool instead of “Erase Chip".
If you have already performed an Erase Chip operation, reprogram the Cypress Secure Bootloader into PSoC 64 MCU by using the re-provisioning instructions from PSoC® 64 Secure MCU Secure Boot SDK User Guide.
Labels
Rate this article: