cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

USB-to-Parallel Converter Using EZ-USB® FX2LP™ – KBA88219

Anonymous
Not applicable

USB-to-Parallel Converter Using EZ-USB® FX2LP™ – KBA88219

Version: **

Translation - Japanese: EZ-USB®FX2LP™を使用したUSB-パラレルコンバーター – KBA88219 - Community Translated (JA)

Question: How can you use EZ-USB® FX2LP™ to make a USB-to-parallel converter? The data received over the USB should be made available on a parallel data bus on the GPIO pins.

Answer:

There are two methods to implement a USB-to-parallel interface in FX2LP.

  •   The GPIF or slave FIFO mode of FX2LP can be used, depending on the external device that is being interfaced with FX2LP.
  •   Without using the GPIF or slave FIFO interface, firmware can be written to implement the same using the 8051 core.
0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Mar 10, 2014 01:43 AM
Updated by:
Anonymous
 
Contributors