Suspend to USB device using EZ-USB Control panel/Cyconsole/control center
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Can a suspend condition be sent to USB device using EZ-USB Control panel/Cyconsole/Control center?
Answer:
No. Suspend condition cannot be sent to a USB device using EZ-USB Control panel/Cyconsole/Control center. It is initiated by the host when it is going into power saving modes or standby.A USB device will enter suspend when there is no activity on the bus for greater than 3.0ms.
- Tags:
- usb controllers
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous