Some problem using MB9BF121K to drive a PMSM

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

hello, I porting the firmware on http://www.cypress.com/applications/home-appliances/inverter-fan-motor  to MB9BF121K, but motor can not startup.

my questions:

     1. can this FW used on MB9BF121K?

     2. In this FW, there is a file named Customer_Interface.c, could you give me some documents to disscuss these parameters?

     3. Could you give me some other advice?

thanks a lot.

0 Likes
1 Solution
lock attach
Attachments are accessible only for community members.
GeonaP_26
Moderator
Moderator
Moderator
250 solutions authored 100 solutions authored 50 solutions authored

We are migrating the FM0+/FM3 based Fan Motor solution to PSoC family. We would recommend to use PSoC 4 S2 based Inverted Fan Motor Control. For this, please use attached PSoC Creator project along with motor control library. Please refer to attached DC Fan Motor Interface and schematic document for more details.

View solution in original post

2 Replies
lock attach
Attachments are accessible only for community members.
GeonaP_26
Moderator
Moderator
Moderator
250 solutions authored 100 solutions authored 50 solutions authored

We are migrating the FM0+/FM3 based Fan Motor solution to PSoC family. We would recommend to use PSoC 4 S2 based Inverted Fan Motor Control. For this, please use attached PSoC Creator project along with motor control library. Please refer to attached DC Fan Motor Interface and schematic document for more details.

Anonymous
Not applicable

Was  FM0+/FM3 no longer supported?

I would like use new PSoC 4 to design refer to your attachment.

Are there some software debug document for me?

0 Likes