- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not sure if this is the right forum, but I'll give it a try...
I have a Miller MIG welder with a bad rectifier pack. Specifically, one of three SCRs is bad. It is an EUPEC T568N02TOF. It appears from everywhere I've tried that it is now an obsolete part, and in fact, that is what Miller says when I contacted them. Since Infineon acquired EUPEC, I was hoping there might be a recommended substitute, but I haven't been able to find one.
Can anyone help?
Thanks,
Sparky87
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have looked at the T568N02TOF specifications. my recommendation for you would be T690N. Datasheet for the same is attached. let me know if it suits your requirement.
Regards,
Rishabh S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Wanted to add some information, which could be helpful to you. Please refer to attached image
Regards,
Rishabh S