Nov 16, 2021
10:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2021
10:58 PM
I just programmed CY29421FLXI-ND using the clockwizard. When look at each output (single ended) on the scope, i see both clk+ and clk- in sync. Basically clock complement is missing. was there any setting in clockwizard to set the second output as complement of the 1st output one that i missed?
Solved! Go to Solution.
1 Solution
Nov 18, 2021
03:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2021
03:21 AM
Hi @anonymous-sj ,
Can you share the ClockWizard project with us. We can check the settings used in the project for any discrepancies.
Thanks,
Pradipta.
1 Reply
Nov 18, 2021
03:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2021
03:21 AM
Hi @anonymous-sj ,
Can you share the ClockWizard project with us. We can check the settings used in the project for any discrepancies.
Thanks,
Pradipta.