Clocks Forum Discussions
I am using CY3672-FTG for programming CY22392 FXI.
Now CY3672-FTG and CY3672-USB is obsolete. Please suggest alternat kit for programming CY22392 FXI.
Show LessHello
I redesign and old design with CY7B9950AXI.
CY7B9950AXI is discontinued, do you have any replacement or any other recommendation of Multi-Phase PLL Clock Buffer
Show Less
Hello community,
I am looking for an alternative component to the CY25823. The component must not be pin compatible, but function compatible.
Does anybody know an alternative or the possibility to reproduce this component.
Thanks
Regards SAKRDI
Show LessHello!
Could you share the MTBF /FIT data for the MB3773PF ?
Thanks and best regards,
Hi,
I am looking for phase noise specifications for the CY22394 clock generator. Where can I find information on noise performance?
Thanks,
Jim
Show LessHi - which device programmer do I need to purchase for programming of the CY22392?
We have inherited a existing design which we need to reproduce. It seems that the CY22392 was used as a simple divide by three, so alternately is there a simple clock divider that can be recommended for a newer design that doesn't need a hardware programmer?
Regards
Russell
Show LessRegarding CY27410FLTXI(TRAY) and CY27410FLTXIT(Tape and Reel),
Please let us know TRAY specification and Tape and Reel Specification.
Its Device Package is PG-VQFN-48 (48-Pin QFN (7 × 7 × 1.00 mm) LT48D 5.6 × 5.6 E-Pad (Sawn) Package)
Best regars.
Shigeru Seike /TED
Show Less
Hi all,
I'm writing an IIO driver in C for the Cypress CY22801, with communications via I2C.
However, setting the two available output clock channels generically will be difficult, as there are a lot of variables involved.
For example, I will have to calculate the values for PB, PO, Q, and DIVxN, and select the most suitable divider channel (1/2), and set the source controls for the clock outputs, for each clock output - each will affect the other one, also.
i.e. CLK_OUT_X = (2 * (pb + 4) + po) / (q + 2) / DIVxN * CLK_INPUT_FREQ
The CyClocksRT software generates all of this information automatically. Is the source code for this component of the software available, please? Or can a version of this be provided to aid our use of your products?
Many thanks,
Adam
Show LessHi supporters,
I would like to confirm crystal specifications for CY25560SXI.
ESR ,Drive level ,frequency tolerance ,and so on.
I can not find recommended crystal specifications on the datasheet.
Regards
Junichi Nagata
Show Less